About the D4_3_5_route_cfg_change Patch

This patch addresses the following issue:

NOTE:
  1. This patch does not stop or start any service.
  2. This patch does not reboot the appliance.
  3. The patch can be removed (uninstalled).
  4. Patch removal also does not stop or start any service.

Installing the Patch

To install this patch:
  1. Use a telnet client to connect to the administration command-line interface on port 23 on your Mirapoint appliance.

  2. Log in as an administrator.

  3. Issue the following command: 
            Version
    If the result returned is 4.3.5, you can install this patch.

  4. Install the D4_3_5_route_cfg_change patch using the following CLI command:

    5. Update Install ftp://ftp.mirapoint.com/pub/updates/D4_3_5_route_cfg_change

Always check the system log after installing a patch regardless of whether installation succeeds or fails.