Mirapoint Defect Patch: D3_10_6

About the D3_10_6_webcal Patch

This patch addresses three problems associated with ConnectR and WebCal (Standard and Corporate Editions):

Some event IDs were improperly formatted by calendar clients when sending data to the appliance, resulting in corrupted data on the appliance (PR 48428). This patch cleans up incorrect data on the appliance, while a separate client patch (E3_10_ConnectR_4_1_4) provides a repaired client.
The appliance could get into an infinite loop between ConnectR and WebCal, while trying to delete an event (PR 48368).
ConnectR could fail to update an event on the appliance, with the error "Failed adding to event" (PR 48468).

NOTE: This patch restarts the Calendar service. It does not reboot the appliance. The patch can be uninstalled, with the same effect.

Use a telnet client to connect to the administration command-line interface on port 23 on your Mirapoint appliance.

Issue the following command:
```
        Version
```
If version 3.10.6 displays, you can install this patch.


        Update Install ftp://ftp.mirapoint.com/pub/updates/D3_10_6_webcal.mpu3

Always check the system log after installing a patch regardless of whether installation succeeds or fails.